TECATRON ® GF40 - Stock Shapes (rods, plates, tubes)
Main features
-good heat deflection temperature; hydrolysis and superheated steam resistant; high stiffness; very good chemical resistance; high dimensional stability; high creep resistance; inherent flame resistance
Target Industries
-chemical technology; mechanical engineering; oil and gas industry; precision engineering
| Original Document | Technical Datasheet(English) | |||
| Features | High Stiffness/RigidityHeat ResistanceFlame RetardantDimensional StabilityCreep ResistantSteam ResistantChemical ResistanceHydrolysis ResistanceFilled & Reinforced | |||
| Appearance | SheetRodpipeOpaque ColorBeige | |||
| Reinforced | 40% Glass Fiber | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | Internal | |
Moisture /Humidity Absorption | *** % | ASTM D 570 | 24 hrs, 23°C |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** psi | ASTM D638 | 23°C |
Tensile Strength | |||
Break | *** psi | ASTM D638 | 23°C |
Tensile Elongation | |||
Break | *** % | ASTM D638 | 23°C |
Flexural Modulus | *** psi | ASTM D790 | 23°C |
Flexural Strength | |||
- | *** psi | ASTM D790 | 23°C |
Compressive Modulus | *** psi | ASTM D 695 | |
Compressive Strength | *** psi | ASTM D 695 | 1% strain |
Compressive Strength | *** psi | ASTM D 695 | 10% strain |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Specific Heat | *** J/g-°C | - | |
Coefficient of Linear Thermal Expansion | |||
- | *** E-4/°F | ISO 11359-1/-2 | 72 F - 140 F |
Melt Temperature(Tm) | *** °F | ASTM D 2133 | |
Thermal Conductivity | *** W/(m K) | - | |
Continuous Use Temperature | |||
Long term | *** °F | Internal | Long Term |
Temperature at Short Circle Operation | *** °F | Internal | Intermittent |
| Flammability | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Flame Rating | |||
V-0 | *** mm | IEC 60695-11-10 | |
| Electrical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Volume Resistivity | *** Ohm-cm | ASTM D257 | |
Surface Resistivity | *** Ohm | ASTM D257 | |
Dielectric Constant(Permittivity) | |||
1MHz | *** - | ASTM D 150 | |
Dissipation Factor | |||
1 kHz | *** E-4 | ASTM D 150 | 23°C |
1MHz | *** E-4 | ASTM D150 | |
Dielectric Strength | *** kV/in | ASTM D149 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
