TECAPRO® MT white - Stock Shapes (rods, plates, tubes)
Main features
-heat stabilized; autoclavable; biocompatible; good chemical resistance; hydrolysis and superheated steam resistant; low moisture absorption; good slide and wear properties
Target Industries
-medical technology; pharmaceutical industry; food engineering
| Original Document | Technical Datasheet(English) | |||
| Features | Heat StabilizedWear/Abrasion ResistanceLow Friction/WearFood ContactMedical Application/Health CareBiocompatibleSteam ResistantAutoclave SterilizableChemical ResistanceHydrolysis ResistanceLow Moisture Absorption | |||
| Appearance | SheetRodpipeWhite | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | Internal | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** psi | ASTM D638 | 23°C |
Tensile Strength | |||
Yield | *** psi | ASTM D638 | 23°C |
Tensile Elongation | |||
Break | *** % | ASTM D638 | 23°C |
Flexural Modulus | *** psi | ASTM D790 | 23°C |
Flexural Strength | |||
- | *** psi | ASTM D790 | 23°C |
Compressive Modulus | *** psi | ASTM D 695 | 23°C |
Compressive Strength | *** psi | ASTM D 695 | 23°C, 1% Sec |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Izod Unnotched Impact Strengh | |||
23℃ (73℉) | *** ft·lb/in | ASTM D256 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
1.8 Mpa (264 psi)（18.6kg/cm²） | *** °F | ASTM D648 | |
Melt Temperature(Tm) | *** °F | Internal | |
Continuous Use Temperature | |||
Long term | *** °F | Internal | Intermittent |
Long term | *** °F | Internal | Long Term |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
