Homopolymer for Strapping
Formolene® 5100H is a polypropylene homopolymer designed for various extrusion applications, notably strapping. It contains a unique combination of stabilizers and additives, which provides excellent processability and good end use performance.
Formolene® 5100H meets the requirements of the U.S. Food and Drug Administration as specified in 21 CFR 177.1520, covering safe use of polyolefin articles and components of articles intended for direct food contact. For additional information on approved conditions of use for food contact applications, please refer to the “Products” section on our website (http://www.fpcusa.com/ourproducts.html).
This material is free of animal-derived content.
| Original Document | Technical Datasheet(English) | |||
| Features | Food ContactHomopolymer | |||
| Additive | Processing Aid | |||
| Processing | Extrusion | |||
| Compliance | FDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D 1505 | |
Melt Mass Flow Rate(MFR) | |||
230°C/2.16 kg | *** g/10min | ASTM D 1238 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D638 | 50 mm/min |
Tensile Elongation | |||
Yield | *** % | ASTM D638 | 50 mm/min |
Flexural Modulus | *** Mpa | ASTM D790 | 1% Secant, 1.3 mm/min |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Izod Notched Impact Strengh | |||
23℃ (73℉) | *** J/m | ASTM D256 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Rockwell R | *** R | ASTM D785 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
