VERSIFY™ 3300 Elastomer can be used for stretch cling, elastic film and as a blend component in thermoplastic elastomers and thermoplastic olefins. It is a particularly good choice for cast stretch film sealants.
When used as cling additive the grade generates higher unstretched film cling levels and can be used in blends at lower addition levels than needed with VLDPE. It gives consistent performance in hot and cold conditions, retains its characteristics over extended periods and delivers lower noise levels.
Complies with:
U.S. FDA FCN 909
U.S. FDA 21 CFR 175.105(c)(5)
EU, No 10/2011
Consult the regulations for complete details.
| Original Document | Technical Datasheet(English) | |||
| Processing | Cast FilmFilm Extrusion | |||
| Compliance | EU 2011/10/ECFDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
230°C/2.16 kg | *** g/10min | ASTM D 1238 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Break | *** Mpa | ASTM D638 | Compression Molded |
Tensile Elongation | |||
Break | *** % | ASTM D638 | Compression Molded |
Flexural Modulus | *** Mpa | ASTM D790 | 1% Secant, Compression Molded |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | 10s, Compression Molded |
Shore D hardness | *** D | ASTM D 2240 | 10s, Compression Molded |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ASTM D1525 | |
Melt Temperature(Tm) | *** °C | Internal | DSC |
Glass Transition Temperature | *** °C | Internal | |
| Optical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Haze | *** % | ASTM D1003 | 2000 µm, Injection Molded |
Gloss | *** - | ASTM D 523 | 20°, 1000 µm, Compression Molded |
Gloss | *** - | ASTM D 523 | 60°, 1000 µm, Compression Molded |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
