70 Durometer, two-part, 1 to 1 mix, off-white, injection molding grade liquid silicone rubber
Features & Benefits
• Good oil resistance
• Low compression set
• No post-cure
Applications
• Molding
• Seals, O-rings and diaphragms
• Automotive anti-drainback valve
• Oil filter component
| Original Document | Technical Datasheet(English) | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Viscosity | *** Pa-s | ASTM D4287 | Y=0.9s- ¹ |
Viscosity | *** Pa-s | ASTM D4287 | Y=10.0s- ¹ |
Solids Content | *** % | Internal | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ASTM D 412 | As Molded |
- | *** Mpa | ASTM D 412 | Post-Cured |
Tensile Elongation | |||
Break | *** % | ASTM D 412 | As Molded |
Break | *** % | ASTM D 412 | Post-Cured |
Tear Strength | *** kN/m | ASTM D 624 | As Molded |
Tear Strength | *** kN/m | ASTM D 624 | Post-Cured |
Compression Set | *** % | ASTM D 395 | As Molded, 70 hours at 150°C |
Compression Set | *** % | ASTM D 395 | Post-Cured, 70 hours at 150°C |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | As Molded |
Shore A hardness | *** A | ASTM D 2240 | Post-Cured |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
