Two-part, low viscosity silicone elastomer to be used with SILASTIC™ N9162 Flit Plug Encapsulant Catalyst
Features & Benefits
Room temperature cure
Usable at temperatures from -50°C to +250°C
Excellent dielectric properties
Blue colored catalyst for ease of mixing
Highly resistant to moisture, oxidation and weathering
Easily mixed and poured
Easily repaired by cutting away and pouring new material
No heating equipment needed
Composition
Silicone elastomer
Applications
SILASTIC™ 9161 Flit Plug Encapsulant Kit has been formulated especially for use in Flame Proof Connecting Equipment. It can help keep dust and dirt away from connectors, effectively minimizing the risk of arcing. It has been approved for use by Department of Mines, N.S.W and Queensland (Australia) for encapsulation of bolted couplers (Flit plugs) use in mining applications
| Original Document | Technical Datasheet(English) | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | SILASTIC™ 9161 |
Density/Specific Gravity | *** g/cm³ | ASTM D792 | SILASTIC™ N9162 |
Mold Shrinkage | |||
- | *** % | Internal | Linear shrinkage, 24 hours at 70°C |
Viscosity | *** Pa-s | Internal | SILASTIC™ 9161 |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ASTM D 412 | with 2% SILASTIC™ N9162 |
Tensile Elongation | |||
- | *** % | ASTM D 412 | with 2% SILASTIC™ N9162 |
Tear Strength | *** kN/m | ASTM D 624 | with 2% SILASTIC™ N9162 |
Tear Strength | *** kN/m | ASTM D 624 | with 2% SILASTIC™ N9162 |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | with 2% SILASTIC™ N9162 |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Thermal Conductivity | *** W/(m K) | - | with 2% SILASTIC™ N9162 |
| Electrical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Volume Resistivity | *** Ohm-cm | ASTM D257 | with 2% SILASTIC™ N9162 |
Dielectric Constant(Permittivity) | |||
1MHz | *** - | ASTM D 150 | with 2% SILASTIC™ N9162 |
Dissipation Factor | |||
1MHz | *** E-4 | ASTM D150 | with 2% SILASTIC™ N9162 |
Comparative Tracking Index (CTI) | |||
- | *** - | IEC 60112 | with 2% SILASTIC™ N9162 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
