INFUSE™ 9000 Olefin Block Copolymer is a high performance olefin block copolymer that can be widely used in thermoplastic elastomer applications where higher service temperature requirements are needed.
INFUSE 9000 also provides high filler loading capability along with low compression set and good processability.
Main Characteristics:
High upper service temperature performance
Highly flexible with good elastic recovery
Fast set up times for processability
General purpose elastomer
Excellent for compounds and blends
Complies with
EU, No 10/2011
U.S. FDA FCN 424
Consult the regulations for complete details.
| Original Document | Technical Datasheet-ASTM(English) | |||
| Features | Good FlexibilityHeat ResistanceEasy processingThermoplastic ElastomerSoft | |||
| Compliance | EU 2011/10/ECFDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ASTM D638 | 100% Secant, Compression Molded |
Tensile Strength | |||
Break | *** Mpa | ASTM D638 | Compression Molded |
Break | *** Mpa | ASTM D 412 | |
Tensile Elongation | |||
Break | *** % | ASTM D638 | Compression Molded |
Break | *** % | ASTM D 412 | |
Tear Strength | *** kN/m | ASTM D 624 | |
Compression Set | *** % | ASTM D 395 | 23°C |
Compression Set | *** % | ASTM D 395 | 70°C |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Melt Temperature(Tm) | *** °C | Internal | DSC |
Thermo mechanical analysis | *** °C | Internal | 1.00 mm, 1N, 5°C/min |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
