FINGERPRINT™ DFDC-7525 NT is a medium density polyethylene resin produced using Unipol™ process technology. It is intended for use in thin-wall micro irrigation tape applications and profile extrusion applications. DFDC-7525 NT exhibits good draw down characteristics producing tape with a reliable balance of extrusion ease and toughness.
It also has utility as a blending component to modify and improve the physical properties of high pressure, very low density, linear low density, or high density polyethylene resins. Outdoor applications require the addition of UV stabilizer to maintain the excellent properties over extended periods of UV exposure. Dow DFNF-0092 carbon black masterbatch at a 6.5% concentration has been found
to offer suitable UV resistance.
Main Characteristics:
High tensile properties
High elongation properties
Excellent burst strength
Slip Additive: none
Antiblock Additive: none
Industrial Standards Compliance:
ASTM D 3350: cell classification PE234510A
| Original Document | Technical Datasheet-ASTM(English) | |||
| Processing | ExtrusionTube Extrusion | |||
| Compliance | ASTM D3350 | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
190℃/21.6 kg | *** g/10 min | ASTM D 1238 | |
Environmental Stress Cracking Resistance | *** Hours | ASTM D 1693 | F0 |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D638 | |
Break | *** Mpa | ASTM D638 | |
Tensile Elongation | |||
Break | *** % | ASTM D638 | |
Flexural Modulus | *** Mpa | ASTM D790 | |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Brittleness Temperature | *** °C | ASTM D 746 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore D hardness | *** D | ASTM D 2240 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ASTM D1525 | |
Melt Temperature(Tm) | *** °C | Internal | DSC |
Processing Temperature | ***~*** °C | - | Melt Temperature |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
