EVERCAP™ DMDF-1250 NT 7 High Density Polyethylene Resin (HDPE) enables the right performance properties to meet demanding closure and fitment application needs. It is intended for use in both compression and injection molded closure applications including carbonated soft drink and hot fill closures. Its unique properties also make it suitable for living hinge closure applications. This resin has been designed to meet demanding performance requirements, especially in the areas of environmental stress crack resistance, impact strength, and sensory, while maintaining good processing characteristics beneficial to molders.
Main Characteristics:
Excellent ESCR, Stiffness, and Impact Strength
Excellent Sensory Properties
Excellent Processing Characteristics
Contains Slip Agent
Complies with:
U.S. FDA 21 CFR 177.1520(c)3.2a
Europe Commission Regulation (EU) No 10/2011
Canadian HPFB No Objection
Consult the regulations for complete details.
| Original Document | Technical Datasheet-ASTM(English) | |||
| Additive | Slip agent | |||
| Processing | InjectionCompression Moulding | |||
| Compliance | EU 2011/10/ECFDAHPFB (Canada) | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
Environmental Stress Cracking Resistance | *** Hours | ASTM D 1693 | 50°C, 10% Igepal, F50 |
Environmental Stress Cracking Resistance | *** Hours | ASTM D 1693 | 50°C, 100% Igepal, F50 |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D638 | |
Break | *** Mpa | ASTM D638 | |
Tensile Elongation | |||
Yield | *** % | ASTM D638 | |
Break | *** % | ASTM D638 | |
Flexural Modulus | *** Mpa | ASTM D790 | 2% Secant |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore D hardness | *** D | ASTM D 2240 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
0.45 Mpa (66 psi)（4.6kg/cm²） | *** °C | ASTM D648 | Unannealed |
Vicat Softening Temperature(VST) | *** °C | ASTM D1525 | |
Melt Temperature(Tm) | *** °C | Internal | DSC |
Freezing temperature | *** °C | Internal | DSC |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
