ENGAGE™ HM 7387 Polyolefin Elastomer is an ethylene-butene copolymer that has higher molecular weight, better toughness, and higher melt strength than other commercially available polyolefin elastomers.
It can serve as an extender for SEBS, impart lower gloss in hard TPOs, provide the basis for flexible soft-touch compounds, and is well suited for extruded applications such as wire and cable. ENGAGE HM 7387 is also useful for impact modification of various thermoplastic resins.
Main Characteristics:
Pellet form
High melt strength
Improved toughness
Applications:
Polymer modification
Extender for SEBS
Soft-touch compounds
Reduced gloss TPOs
Wire and cable
Impact modification
| Original Document | Technical Datasheet-ASTM(English) | |||
| Appearance | Pellets/Granules | |||
| Processing | Compounding | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
Viscosity | *** MU | ASTM D1646 | Mooney Viscosity (ML 1+4, 250°F (121°C)) |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ASTM D638 | 100% Secant, 510 mm/min, Compression Molded |
Tensile Strength | |||
Break | *** Mpa | ASTM D638 | 510 mm/min, Compression Molded |
Tensile Elongation | |||
Break | *** % | ASTM D638 | 510 mm/min, Compression Molded |
Flexural Modulus | *** Mpa | ASTM D790 | 1% Secant : Compression Molded |
Flexural Modulus | *** Mpa | ASTM D790 | 2% Secant : Compression Molded |
Tear Strength | *** kN/m | ASTM D 624 | Die C |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | 1 sec, Compression Molded |
Shore D hardness | *** D | ASTM D 2240 | 1 sec, Compression Molded |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ASTM D1525 | |
Melt Temperature(Tm) | *** °C | Internal | DSC, 10°C/min |
Glass Transition Temperature | *** °C | Internal | |
Freezing temperature | *** °C | Internal | DSC |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
