ENGAGE™ 8003 EL Polyolefin Elastomer is an ethylene-octene copolymer that has excellent flow characteristics and performs well in a wide variety of Wire & Cable elastomer applications. ENGAGE 8003 EL provides superb impact properties and also provides high filler loading capability and outstanding peroxide cure capability. When cross-linked by peroxide, silane, or irradiation, it gives exceptional heat aging, compression set, and weather resistance properties, and may be used to produce high performance electrical insulation and jacketing.
Main Characteristics:
Pellet form
Excellent flow characteristics
High filler loading
Peroxide, silane, and radiation curable
Exceptional heat aging, compression set, and weather resistance when cured
Applications:
Wire and cable
Complies with:
EU, No 10/2011
Japan Hygienic Olefin and Styrene Plastics Association
NSF/ANSI Standard 51-Food Equipment Materials
U.S. FDA 21 CFR 177.1520(c)3.2c
| Original Document | Technical Datasheet-ASTM(English) Technical Datasheet-ASTM(Chinese) | |||
| Processing | Wire & Cable ExtrusionCompounding | |||
| Compliance | ANSIEU 2011/10/ECFDAJHOSPANSF | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
Viscosity | *** MU | ASTM D1646 | Mooney Viscosity (ML 1+4, 250°F (121°C)) |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ASTM D638 | 100% Secant, 510 mm/min, Compression Molded |
Tensile Strength | |||
Break | *** Mpa | ASTM D638 | 510 mm/min, Compression Molded |
Tensile Elongation | |||
Break | *** % | ASTM D638 | 510 mm/min, Compression Molded |
Flexural Modulus | *** Mpa | ASTM D790 | 1% Secant : Compression Molded |
Flexural Modulus | *** Mpa | ASTM D790 | 2% Secant : Compression Molded |
Tear Strength | *** kN/m | ASTM D 624 | Die C |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | Compression Molded |
Shore D hardness | *** D | ASTM D 2240 | Compression Molded |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ASTM D1525 | |
Melt Temperature(Tm) | *** °C | Internal | DSC, 10°C/min |
Glass Transition Temperature | *** °C | Internal | |
Freezing temperature | *** °C | Internal | DSC |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
