ENGAGE™ 7447 is a high ethylene butene melt flow, low density copolymer designed for use alone or in combination with our other elastomers to provide the tailored solutions in polymer modifications applications.
Main Characteristics:
Pellet form
Low Density
Applications:
Polymer modification
Blends
Complies with Government / Industry Standards:
FDA FCN 368
EU, No 10/2011
| Original Document | Technical Datasheet-ASTM(English) | |||
| Appearance | Pellets/Granules | |||
| Processing | Compounding | |||
| Compliance | EU 2011/10/ECFDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
Viscosity | *** MU | ASTM D1646 | Mooney Viscosity (ML 1+4, 250°F (121°C)) |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ASTM D638 | 100% Secant, 510 mm/min, Compression Molded |
Tensile Strength | |||
Break | *** Mpa | ASTM D638 | 510 mm/min, Compression Molded |
Tensile Elongation | |||
Break | *** % | ASTM D638 | 510 mm/min, Compression Molded |
Flexural Modulus | *** Mpa | ASTM D790 | 1% Secant : Compression Molded |
Flexural Modulus | *** Mpa | ASTM D790 | 2% Secant : Compression Molded |
Tear Strength | *** kN/m | ASTM D 624 | Die C |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | Compression Molded |
Shore D hardness | *** D | ASTM D 2240 | Compression Molded |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Melt Temperature(Tm) | *** °C | Internal | DSC, 10°C/min |
Glass Transition Temperature | *** °C | Internal | |
Freezing temperature | *** °C | Internal | DSC |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
