ELITE™ AT 6202 Enhanced Polyethylene Resin is an enhanced LLDPE ethylene-octene copolymer from Dow. This grade is a fully formulated sealant resin designed for demanding applications where hot tack strength is a key requirement.
Main Characteristics
High Hot Tack Strength
Broad Hot Tack Window
Low Heat Seal Initiation Temperature
High Throughput Resin with excellent bubble stability
Complies with:
U.S. FDA FCN 424
Canadian HPFB No Objection
EU, No 20/2011
Consult the regulations for complete details.
| Original Document | Technical Datasheet-ASTM(English) | |||
| Additive | Processing AidSlip agentAntiblock | |||
| Processing | Blown Film | |||
| Compliance | EU 2011/10/ECFDAHPFB (Canada) | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Density/Specific Gravity | *** g/cm³ | Internal | Base Density |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Melt Temperature(Tm) | *** °C | Internal | DSC |
| Optical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Haze | *** % | ASTM D1003 | 25.4 µm |
Gloss | *** - | ASTM D 2457 | 45°, 25.4 µm |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D 882 | MD, 25 µm |
Yield | *** Mpa | ASTM D 882 | TD, 25 µm |
Break | *** Mpa | ASTM D 882 | MD, 25 µm |
Break | *** Mpa | ASTM D 882 | TD, 25 µm |
Tensile Elongation | |||
Break | *** % | ASTM D 882 | MD, 25 µm |
Break | *** % | ASTM D 882 | TD, 25 µm |
Piercing strength | *** N | Internal | 25 µm |
Puncture resistance | *** J/cm³ | Internal | 25 µm |
Puncture resistance | *** J | Internal | 25 µm |
Elmondorf Tear | *** g | ASTM D 1922 | MD, 25 µm |
Elmondorf Tear | *** g | ASTM D 1922 | TD, 25 µm |
Secant Modulus | *** Mpa | ASTM D 882 | 2% Secant, MD, 25 µm |
Secant Modulus | *** Mpa | ASTM D 882 | 2% Secant, TD, 25 µm |
Dart Drop Impact | *** g | ASTM D 1709 | 25 µm |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
