ELITE™ 5400G Enhanced Polyethylene Resin is a copolymer produced via INSITE™ Technology from Dow. It offers a unique combination of low seal initiation, moderate stiffness and low blocking tendencies for good performance on automated packaging equipment.
For food and specialty packaging films
Extremely high impact resistance and good tear properties
Good optical properties
Complies with:
U.S. FDA FCN 424
EU, No 10/2011
Canadian HPFB No Objection
Consult the regulations for complete details.
| Original Document | Technical Datasheet-ASTM(English) | |||
| Processing | Blown Film | |||
| Compliance | EU 2011/10/ECFDAHPFB (Canada) | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Density/Specific Gravity | *** g/cm³ | Internal | Base Density |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ASTM D1525 | |
Melt Temperature(Tm) | *** °C | Internal | DSC |
| Optical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Haze | *** % | ASTM D1003 | |
Gloss | *** - | ASTM D 2457 | 45° |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D 882 | MD |
Yield | *** Mpa | ASTM D 882 | TD |
Break | *** Mpa | ASTM D 882 | MD |
Break | *** Mpa | ASTM D 882 | TD |
Tensile Elongation | |||
Break | *** % | ASTM D 882 | MD |
Break | *** % | ASTM D 882 | TD |
Piercing strength | *** N | Internal | 25 µm |
Puncture resistance | *** J/cm³ | Internal | 25 µm |
Puncture resistance | *** J | Internal | 25 µm |
Film Toughness | *** J/cm³ | ASTM D882 | MD |
Film Toughness | *** J/cm³ | ASTM D882 | TD |
Elmondorf Tear | *** g | ASTM D 1922 | MD |
Elmondorf Tear | *** g | ASTM D 1922 | TD |
Secant Modulus | *** Mpa | ASTM D 882 | 1% Secant, MD |
Secant Modulus | *** Mpa | ASTM D 882 | 1% Secant, TD |
Secant Modulus | *** Mpa | ASTM D 882 | 2% Secant, MD |
Secant Modulus | *** Mpa | ASTM D 882 | 2% Secant, TD |
Dart Drop Impact | *** g | ASTM D 1709 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
