HFDA-9217 Black, with a density of 0.92, is a is a low-density, crosslinkable, black colored polyethylene compound with 0.5% carbon black designed for area power distribution wires covering up to 35 kV. It has the following important advantages:
Good thermal stability and weather resistivity
Excellent tracking resistance
High curing speed
| Original Document | Technical Datasheet(English) | |||
| Appearance | Black | |||
| Processing | Wire & Cable Extrusion | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
Environmental Stress Cracking Resistance | *** Hours | ASTM D 1693 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ASTM D 638 | |
Tensile Elongation | |||
Break | *** % | ASTM D638 | |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Brittleness Temperature | *** °C | ASTM D 746 | F50 |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore D hardness | *** D | ASTM D 2240 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Processing Temperature | ***~*** °C | - | |
Hot Set | *** % | IEC 60502 | Cracking Resistance |
| Electrical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Volume Resistivity | *** Ohm-cm | ASTM D257 | |
Dielectric Constant(Permittivity) | |||
1MHz | *** - | ASTM D1531 | |
Dissipation Factor | |||
1MHz | *** E-4 | ASTM D1531 | |
| Aging | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength(Heat Aging) | *** % | ASTM D638 | Retention, 168 hrs, 150°C |
Elonggation(Heat Aging) | *** % | ASTM D638 | Retention, 168 hrs, 150°C |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
