Dow LLDPE 1613.11 is a Linear Low Density Polyethylene Resin, 1-hexene copolymer, produced in the Solution process. This resin is designed to be used in blown extrusion to produce films for industrial applications and consumer packaging. It contains slip and antiblock additives.
Complies with:
U.S. FDA, 21 CFR 177.1520(c)3.2a
Europe Commission Regulation (EU) No 10/2011 (See NOTES)
Consult the regulations for complete details.
| Original Document | Technical Datasheet-ASTM(English) | |||
| Additive | Slip agentAntiblock | |||
| Processing | Blown Film | |||
| Compliance | EU 2011/10/ECFDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Density/Specific Gravity | *** g/cm³ | Internal | Base Density |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
| Optical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Haze | *** % | ASTM D1003 | 50.8 µm |
Gloss | *** - | ASTM D 2457 | 45°, 50.8 µm |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D 882 | MD, 51 µm |
Yield | *** Mpa | ASTM D 882 | TD, 51 µm |
Break | *** Mpa | ASTM D 882 | MD, 51 µm |
Break | *** Mpa | ASTM D 882 | TD, 51 µm |
Tensile Elongation | |||
Break | *** % | ASTM D 882 | MD, 51 µm |
Break | *** % | ASTM D 882 | TD, 51 µm |
Puncture resistance | *** J/cm³ | Internal | 51 µm |
Elmondorf Tear | *** g | ASTM D 1922 | MD, 51 µm |
Elmondorf Tear | *** g | ASTM D 1922 | TD, 51 µm |
Secant Modulus | *** Mpa | ASTM D 882 | 2% Secant, MD, 51 µm |
Secant Modulus | *** Mpa | ASTM D 882 | 2% Secant, TD, 51 µm |
Dart Drop Impact | *** g | ASTM D 1709 | 51 µm |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
