DOW LDPE 410E Low Density Polyethylene Resin is a high clarity resin designed for lamination film and clarity over wrap applications. This resin does not contain slip and antiblock additives. It can be readily extruded using conventional blown film techniques utilising melt temperatures between 170 and 195°C; and cast film using temperatures between 180 and 240 °C. This resin when properly fabricated shows: excellent processability and draw down, outstanding toughness and impact properties, superior optical properties, excellent tensile and tear strength.
Applications:
Lamination films
Food packaging films
Hygiene films
Cast films
Air-bubble film
Foamed PE
Extrusion coating
Complies with:
U.S. FDA 21 CFR 177.1520(c)2.2
EU, No 10/2011
Consult the regulations for complete details.
| Original Document | Technical Datasheet(English) | |||
| Processing | Cast FilmBlown FilmExtrusion Coating | |||
| Compliance | EU 2011/10/ECFDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ISO 1133 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Coefficient of Friction | ***~*** - | ASTM 1894 | vs. Itself - Dynamic |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ISO 306/A | |
Processing Temperature | ***~*** °C | - | Melt Temperature |
| Optical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Haze | *** % | ASTM D1003 | 50 µm |
Gloss | *** - | ASTM D 2457 | 20°, 50 µm |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D 882 | MD, 50 µm |
Yield | *** Mpa | ASTM D 882 | TD, 50 µm |
Break | *** Mpa | ASTM D 882 | MD, 50 µm |
Break | *** Mpa | ASTM D 882 | TD, 50 µm |
Tensile Elongation | |||
Break | *** % | ASTM D 882 | MD, 50 µm |
Break | *** % | ASTM D 882 | TD, 50 µm |
Elmondorf Tear | *** g | ASTM D 1922 | MD, 50 µm |
Elmondorf Tear | *** g | ASTM D 1922 | TD, 50 µm |
Secant Modulus | *** Mpa | ASTM D 882 | 2% Secant, MD, 50 µm |
Secant Modulus | *** Mpa | ASTM D 882 | 2% Secant, TD, 50 µm |
Dart Drop Impact | *** g | ASTM D 1709 | 50 µm |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
