DOW DMDA-8940 NT 7 High Density Polyethylene (HDPE) Resin is produced via UNIPOL™ Process Technology from Dow and is intended for use in a broad range of injection molding applications such as housewares, toys, food containers and pails. This resin has been designed to provide an excellent balance of toughness, environmental stress crack resistance and processability.
Injection molding
For injection molded housewares, toys, food containers and pails
Excellent balance of toughness, stress crack resistance and processability
Very narrow molecular weight distribution
Complies with U.S. FDA 21 CFR 177.1520 (c)3.2a
Complies with U.S. FDA -DMF
Complies with Canadian HPFB No Objection
Complies with EU, No 10/2011
Consult the regulations for complete details.
| Original Document | Technical Datasheet-ASTM(English) | |||
| Features | Good ToughnessEasy processingESCR | |||
| Processing | Injection | |||
| Compliance | Drug Master FileEU 2011/10/ECFDAHPFB (Canada) | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D638 | |
Break | *** Mpa | ASTM D638 | |
Tensile Elongation | |||
Yield | *** % | ASTM D638 | |
Break | *** % | ASTM D638 | |
Flexural Modulus | *** Mpa | ASTM D790 | 2% Secant |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Impact | *** kJ/m² | ASTM D 1822 | Type S |
Brittleness Temperature | *** °C | ASTM D 746 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore D hardness | *** D | ASTM D 2240 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
0.45 Mpa (66 psi)（4.6kg/cm²） | *** °C | ASTM D648 | Unannealed |
Vicat Softening Temperature(VST) | *** °C | ASTM D1525 | |
Melt Temperature(Tm) | *** °C | Internal | DSC |
Freezing temperature | *** °C | Internal | DSC |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
