DOWLEX IP 20 Polyethylene Resin is a Linear Low Density Polyethylene produced at Dow and it is intended for injection molding applications. This resin presents superior properties compared to a Polyethylene of similar melt index and density. Its main characteristics are: high stiffness, good resistance at low temperatures, exceptional gloss and reduced warp in large pieces
Main Applications:
Injection Molded parts
Food ware and house ware
Toys
Boxes and trays
Caps and lids
Carrier resin for compounding (masterbatches)
Complies with:
U.S. FDA 21 CFR 177.1520(c )3.2a
Europe Commission Regulation (EU) No 10/2011
Latin America MERCOSUR - Applications in Contact with Foods: This product complies with the MECOSUR Regulations: GMC 56/92; GMC 39/19 and GMC 02/12.
Consult the regulations for complete details.
| Original Document | Technical Datasheet(English) | |||
| Processing | Injection | |||
| Compliance | EU 2011/10/ECFDAMERCOSUR | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Density/Specific Gravity | *** g/cm³ | Internal | Base Density |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
Environmental Stress Cracking Resistance | *** Hours | ASTM D 1693 | 50°C, 100% Igepal, F50 |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D638 | |
Break | *** Mpa | ASTM D638 | |
Tensile Elongation | |||
Break | *** % | ASTM D638 | |
Flexural Modulus | *** Mpa | ASTM D790 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore D hardness | *** D | ASTM D 2240 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Processing Temperature | ***~*** °C | - | |
Mould temperature | ***~*** °C | - |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
