DOWLEX™ 3010 Polyethylene Resin is a polyethylene polymer designed to offer high performance properties such as excellent Environmental Stress Crack Resistance (ESCR), tear strength, abrasion resistance, and strong heat seals in thin extrusion coatings.
Linear Low Density Polyethylene
For flexible packaging, overwraps and lamination applications
Complies with:
U.S. FDA 21 CFR 177.1520 (c)
Canadian HPFB No Objection (With Limitations)
EU, No 10/2011
Japan Hygienic Styrene Plastics Association
This resin may be used to manufacture articles for use in packing or holding food during cooking. This statement refers to the extraction limitations only, not to the product's physical utility.
Consult the regulations for complete details.
| Original Document | Technical Datasheet(English) | |||
| Processing | Extrusion Coating | |||
| Compliance | EU 2011/10/ECFDAHPFB (Canada)JHOSPA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Density/Specific Gravity | *** g/cm³ | Internal | Base Density |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
Neck-in | *** cm | Internal | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Coefficient of Friction | *** - | ASTM 1894 | vs. Itself - Dynamic |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ASTM D1525 | |
Melt Temperature(Tm) | *** °C | Internal | |
Processing Temperature | ***~*** °C | - | |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Water Vapor Transmission Rate | *** g.mm/m².24hr | ASTM F 1249 | |
Seal Initiation Temperature | *** ℃ | Internal |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
