DOWLEX 2607 GC Polyethylene Resin is specifically designed for large/high output cast film lines to make high performance industrial stretch films.
Films made from DOWLEX 2607 GC Polyethylene Resin exhibit an excellent balance of processability, mechanical and stretchability performance properties.
DOWLEX 2607 GC Polyethylene Resin is to be used as a core resin in coextruded cast film structures for films in the thickness range between 10 and 35 microns.
Complies with:
EU, No10/2011
U.S. FDA FCN 741
Consult the regulations for complete details.
| Original Document | Technical Datasheet(English) | |||
| Processing | Cast Film | |||
| Compliance | EU 2011/10/ECFDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Density/Specific Gravity | *** g/cm³ | Internal | Base Density |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D 882 | MD, 23 µm |
Yield | *** Mpa | ASTM D 882 | TD, 23 µm |
Break | *** Mpa | ASTM D 882 | MD, 23 µm |
Break | *** Mpa | ASTM D 882 | TD, 23 µm |
Tensile Elongation | |||
Break | *** % | ASTM D 882 | MD, 23 µm |
Break | *** % | ASTM D 882 | TD, 23 µm |
Piercing strength | *** N | Internal | 23 µm |
Puncture resistance | *** J | Internal | 23 µm |
Elmondorf Tear | *** g | ASTM D 1922 | MD, 23 µm |
Elmondorf Tear | *** g | ASTM D 1922 | TD, 23 µm |
Dart Drop Impact | *** g | ASTM D 1709 | 23 µm |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
