Linear Low Density Polyethylene
Improved thermal stability for high stiffness film applications
Complies with
U.S. FDA 21 CFR 177.1520 (c) 3.2a
EU, No 10/2011
Japan Hygienic Olefin and Styrene Plastics Association
U.S. FDA-DMF
HPFB (Canada), No Objection
Consult the regulations for complete details
| Original Document | Technical Datasheet-ASTM(English) | |||
| Compliance | Drug Master FileEU 2011/10/ECFDAHPFB (Canada)JHOSPA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ASTM D1525 | |
Melt Temperature(Tm) | *** °C | Internal | DSC |
Processing Temperature | *** °C | - | Extrusion |
| Optical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Haze | *** % | ASTM D1003 | 25.4 µm |
Gloss | *** - | ASTM D 2457 | 45°, 25.4 µm |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D 882 | MD, 25 µm |
Yield | *** Mpa | ASTM D 882 | TD, 25 µm |
Break | *** Mpa | ASTM D 882 | MD, 25 µm |
Break | *** Mpa | ASTM D 882 | TD, 25 µm |
Tensile Elongation | |||
Break | *** % | ASTM D 882 | MD, 25 µm |
Break | *** % | ASTM D 882 | TD, 25 µm |
Puncture resistance | *** J/cm³ | Internal | 25 µm |
Film Toughness | *** J/cm³ | ASTM D882 | MD, 25 µm |
Film Toughness | *** J/cm³ | ASTM D882 | TD, 25 µm |
Elmondorf Tear | *** g | ASTM D 1922 | MD, 25 µm |
Elmondorf Tear | *** g | ASTM D 1922 | TD, 25 µm |
Dart Drop Impact | *** g | ASTM D 1709 | 25 µm |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
