CEFOR 1050P is a Linear Low Density Polyethylene Resin 1-Butene copolymer, produced in the Solution process. This resin is designed to be used in cast extrusion to produce films for stretch and health & hygiene applications.
Complies with:
European Commission Regulation (EU) No 10/2011
U.S. FDA 21 CFR 177.1520(c)3.2a
Consult the regulation for complete details
Additive:
Antiblock: No
Slip: No
Processing Aid: No
| Original Document | Technical Datasheet(English) | |||
| Processing | Cast Film | |||
| Compliance | EU 2011/10/ECFDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Density/Specific Gravity | *** g/cm³ | Internal | Base Density |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Processing Temperature | *** °C | - | Extrusion |
| Optical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Haze | *** % | ASTM D1003 | 23.9 µm |
Gloss | *** - | ASTM D 2457 | 45°, 23.9 µm |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D 882 | MD, 24 µm |
Yield | *** Mpa | ASTM D 882 | TD, 24 µm |
Break | *** Mpa | ASTM D 882 | MD, 24 µm |
Break | *** Mpa | ASTM D 882 | TD, 24 µm |
Tensile Elongation | |||
Break | *** % | ASTM D 882 | MD, 24 µm |
Break | *** % | ASTM D 882 | TD, 24 µm |
Puncture resistance | *** J/cm³ | Internal | 24 µm |
Elmondorf Tear | *** g | ASTM D 1922 | MD, 24 µm |
Elmondorf Tear | *** g | ASTM D 1922 | TD, 24 µm |
Secant Modulus | *** Mpa | ASTM D 882 | 2% Secant, MD, 24 µm |
Secant Modulus | *** Mpa | ASTM D 882 | 2% Secant, TD, 24 µm |
Dart Drop Impact | *** g | ASTM D 1709 | 24 µm |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
