AFFINITY™ PT 1450G1 Polyolefin Plastomer is produced via INSITE™ Technology. It is an ethylene alpha-olefin resin for monolayer and coextrusion coating that offers excellent low temperature seal initiation, ultimate seal strength, adhesion to (OPP) and good taste and odor performance.
Monolayer and coextrusion coating for packaging applications
Recommended for use with Oriented Polypropylene (OPP as a tie layer or sealant)
Coextruded with acid copolymer as a cost effective foil or PET sealant
Complies with U.S. FDA
Consult the regulations for complete details. (See NOTES)
Note: It is the responsibility of the manufacturer of the food contact article to ensure the article is suitable for its intended use. Manufacturers should be aware that foods with a high oil content may compromise the integrity of the packaging.
| Original Document | Technical Datasheet-ASTM(English) | |||
| Compliance | FDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
Neck-in | *** cm | Internal | 316°C, 25.4 µm |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ASTM D1525 | |
Melt Temperature(Tm) | *** °C | Internal | DSC |
Processing Temperature | ***~*** °C | - | Extrusion |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Seal Initiation Temperature | *** ℃ | Internal | 25 µm |
| Additional Information | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Adhesion Strength | *** N/mm | - | 288°C, Adhesion to OPP |
Adhesion Strength | *** N/mm | - | 316°C, Adhesion to OPP |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
