Daplen EE112AE is a mineral filled elastomer modified polypropylene compound intended for injection moulding.
This material provides excellent paintability, very good impact/stiffness balance and low thermal expansion.
Applications
Daplen EE112AE has been developed especially for the automotive industry and is suitable for applications like: Bumpers Automotive exterior applications
Special Features
Primerless paintable allowing optimisation of painting cycle time and reduction of system cost Low density with good impact/stiffness balance enabling weight reduction Low thermal expansion over a broad temperature scale for zero-gap applications
| Original Document | Technical Datasheet-ISO(English) Summary Data Sheets-Automotive(English) | |||
| Features | Good StiffnessGood Impact ResistanceLow CLTEGood PaintablilityFilled & Reinforced | |||
| Processing | Injection | |||
| Reinforced | MineralElastomer | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Melt Mass Flow Rate(MFR) | |||
230°C/2.16 kg | *** g/10min | ISO 1133 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ISO 527-2 | 50 mm/min |
Flexural Modulus | *** Mpa | ISO 178 | 2 mm/min |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Charpy Notched Impact Strengh | |||
-20℃ (-4℉) | *** kJ/m² | ISO 179/1eA | |
23℃ (73℉) | *** kJ/m² | ISO 179/1eA | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
0.45 Mpa (66 psi)（4.6kg/cm²） | *** °C | ISO 75-2 | |
Coefficient of Linear Thermal Expansion | |||
- | *** E-6/K | Internal | -30 °C/80 °C |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
