Bormed SB815MO is a polypropylene random-heterophasic copolymer intended for evaluation for use in Healthcare applications.
This grade is designed for production of bottles & ampoules for use in Pharmaceutical & Diagnostic applications manufactured via BFS, Extrusion or Injection blow moulding technologies. Final articles can be steam sterilised at 121 °C and are characterised by flexibility, allowing a good collapsibility and good optical properties. Haze of 0,5 mm and 1 mm injection moulded plaques is approximately 10 % and 28 % respectively.
CAS-No. 9010-79-1
Applications
Bormed SB815MO has been evaluated according to different regulations and norms. Typical applications are mentioned below for Medical and Diagnostic devices or Pharmaceutical packaging. However, Borealis should be consulted for final approval to evaluate the use of Bormed SB815MO .
Bottles for IV-solutions Bottles for irrigation solutions Ampoules for injectable solutions
The customer should be aware that Bormed products may only be used in applications which are pre-approved for evaluation by Borealis received in the form of a risk assessment form (RAF) review response. Without such preapproval, no use of the grade shall be made. In case of doubt, the customer should seek pre-approval for evaluation from Borealis to proceed through their Sales or technical contact. Borealis makes no warranties beyond what is contained in this product datasheet and the customer is responsible for reading and accepting the disclaimer as contained in this product datasheet.
Special Features
Good transparency Sterilisable Good flexibility
| Original Document | Technical Datasheet-ISO(English) | |||
| Features | Good FlexibilityGood optical propertiesLight TransmissionMedical Application/Health CareSteam Resistant | |||
| Processing | ExtrusionInjection Blow MoldingBlow-Fill-Seal(BFS) | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Melt Mass Flow Rate(MFR) | |||
230°C/2.16 kg | *** g/10min | ISO 1133 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ISO 527-2 | 1 mm/min |
Tensile Strength | |||
Yield | *** Mpa | ISO 527-2 | 50 mm/min |
Tensile Elongation | |||
Yield | *** % | ISO 527-2 | 50 mm/min |
Flexural Modulus | *** Mpa | ISO 178 | |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Charpy Notched Impact Strengh | |||
0℃ (32℉) | *** kJ/m² | ISO 179/1eA | |
23℃ (73℉) | *** kJ/m² | ISO 179/1eA | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
0.45 Mpa (66 psi)（4.6kg/cm²） | *** °C | ISO 75-2 | |
Melt Temperature(Tm) | *** °C | ISO 11357-3 | DSC |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
