Bormed™ HE7541-PH is a bimodal high density polyethylene intended for evaluation for use in Healthcare applications. Bormed HE7541-PH is typically used in articles produced via injection moulding. This grade combines high environmental stress crack resistance and easy processing. Material can be sterilised with ethylene oxide, steam and radiation up to 35 kGy; as a result of sterilisation by radiation some minor yellowing can occur.
CAS-No. 25087-34-7
Applications
Bormed HE7541-PH has been evaluated according to different regulations and norms. Typical applications are mentioned below for Medical and Diagnostic devices or Pharmaceutical packaging. However, Borealis should be consulted for final approval to evaluate the use of Bormed HE7541-PH .
Caps and closures Shoulders for tubes Containers for tablets, powder or granules
The customer should be aware that Bormed products may only be used in applications which are pre-approved for evaluation by Borealis received in the form of a risk assessment form (RAF) review response. Without such preapproval, no use of the grade shall be made. In case of doubt, the customer should seek pre-approval for evaluation from Borealis to proceed through their Sales or technical contact. Borealis makes no warranties beyond what is contained in this product datasheet and the customer is responsible for reading and accepting the disclaimer as contained in this product datasheet.
Special Features
Easy processing High ESCR
| Original Document | Technical Datasheet(English) | |||
| Features | Easy processingMedical Application/Health CareGamma ResistanceEtO sterilizableSteam ResistantESCR | |||
| Processing | Injection | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ISO 1133 | |
Environmental Stress Cracking Resistance | *** Hours | ASTM D 1693 | Igepal 10 %, F50 |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ISO 527-2 | 1 mm/min |
Tensile Strength | |||
Yield | *** Mpa | ISO 527-2 | 50 mm/min |
Tensile Elongation | |||
Yield | *** % | ISO 527-2 | 50 mm/min |
Flexural Modulus | *** Mpa | ISO 178 | 2 mm/min |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore D hardness | *** D | ISO 868 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
0.45 Mpa (66 psi)（4.6kg/cm²） | *** °C | ISO 75-2 | |
Melt Temperature(Tm) | *** °C | ISO 11357-3 | DSC |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
