Bormed HD800CF-11 is a polypropylene homopolymer intended for evaluation for use in Healthcare applications. This grade is suitable for the manufacturing of non-oriented cast films on chill roll process and blown films on tubular water quenching process. This grade can also be processed using injection moulding technology.
The grade name suffix -11 is a temporary suffix, which will be removed when catalyst change is completed. SAP code remains the same.
CAS-No. 9003-07-0
Applications
Bormed HD800CF-11 has been evaluated according to different regulations and norms. Typical applications are mentioned below for Medical and Diagnostic devices or Pharmaceutical packaging. However, Borealis should be consulted for final approval to evaluate the use of Bormed HD800CF-11 .
Medical device packaging Closures Pouches for Continuous Ambulatory Peritoneal Dialysis Parenteral nutrition bags Pouches for IV solutions Secondary packaging
The customer should be aware that Bormed products may only be used in applications which are pre-approved for evaluation by Borealis received in the form of a risk assessment form (RAF) review response. Without such preapproval, no use of the grade shall be made. In case of doubt, the customer should seek pre-approval for evaluation from Borealis to proceed through their Sales or technical contact. Borealis makes no warranties beyond what is contained in this product datasheet and the customer is responsible for reading and accepting the disclaimer as contained in this product datasheet.
Special Features
High gloss Low haze Very good heat deformation resistance Sterilisability by means of water steam High stiffness High water vapour barrier
| Original Document | Technical Datasheet-ISO(English) | |||
| Features | High Stiffness/RigidityHeat ResistanceHigh GlossMedical Application/Health CareHomopolymer | |||
| Processing | Cast FilmInjectionFilm ExtrusionBlown Film | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Melt Mass Flow Rate(MFR) | |||
230°C/2.16 kg | *** g/10min | ISO 1133 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Flexural Modulus | *** Mpa | ISO 178 | |
Coefficient of Friction | *** - | ISO 8295 | Film/Film |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Melt Temperature(Tm) | *** °C | ISO 11357-3 | DSC |
| Optical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Haze | *** % | ASTM D1003 | |
Gloss | *** - | ASTM D 2457 | 20 degree |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ISO 527-3 | MD |
- | *** Mpa | ISO 527-3 | TD |
Tensile Elongation | |||
Break | *** % | ISO 527-3 | MD |
Break | *** % | ISO 527-3 | TD |
Tensile Modulus | *** Mpa | ISO 527-3 | MD |
Tensile Modulus | *** Mpa | ISO 527-3 | TD |
Dart Drop Impact | *** J/mm | ISO 7765-2 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
