Borcoat ME3000FC is a maleic anhydride grafted polyethylene compound.
It includes a combination of pigments and stabilisers to ensure long-term thermal stability.
The product is supplied as pellets for melt extrusion. The product is coloured yellow.
Applications
Borcoat ME3000FC is recommended for melt extrusion of field joint coatings, repair patches and for hot applied tapes/sheets on buried or submerged pipelines. Steel Pipe Coating
Specifications
Borcoat ME3000FC is intended to fulfil the following international standard: ISO 21809-3, FJC type 5E
Special Features
Borcoat ME3000FC is a reactive top coat polyethylene compound that can be hot applied directly onto an epoxy pre-coated pipe or as a hot applied tape/sheet together with the powder adhesive Borcoat™ ME0433 .
| Original Document | Technical Datasheet-ISO(English) | |||
| Features | Heat Stabilized | |||
| Appearance | Pellets/GranulesYellow | |||
| Processing | ExtrusionCoating | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | Compound |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ISO 1133 | |
Environmental Stress Cracking Resistance | *** Hours | ASTM D 1693 | 50 °C, Igepal 10 %, F0 |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ISO 527-2 | 23 °C, 50 mm/min |
Break | *** Mpa | ISO 527-2 | 23 °C, 50 mm/min |
Tensile Elongation | |||
Break | *** % | ISO 527-2 | -45°C, 50 mm/min |
Break | *** % | ISO 527-2 | 23 °C, 50 mm/min |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Brittleness Temperature | *** °C | ASTM D 746 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore D hardness | *** D | ISO 868 | 1 s |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ISO 306/A50 | 10 N |
Melt Temperature(Tm) | *** °C | ISO 11357-3 | DSC |
| Additional Information | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Oxidative Induction Time | *** Min | ISO 11357 | 200 °C |
Adhesion Strength | *** N/mm | ISO 21809-1 | 3 layer, 23 °C |
Adhesion Strength | *** N/mm | ISO 21809-1 | 3 layer, 80 °C |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
