FR1125MOB is a polypropylene compound intended for injection moulding.
Special Features
-stiffness and impact balance
-stiffness at low density
-thermal stability
| Original Document | Technical Datasheet-ISO(English) | |||
| Features | Good StiffnessGood Impact ResistanceHeat StabilizedLow Density | |||
| Processing | Injection | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Melt Mass Flow Rate(MFR) | |||
230°C/2.16 kg | *** g/10min | ISO 1133 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Flexural Modulus | *** Mpa | ISO 178 | 2 mm/min |
Flexural Strength | |||
- | *** Mpa | ISO 178 | |
| Flammability | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Glow Wire Flammability Index(GWFI) | |||
1mm | *** °C | IEC 60695-2-12 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
