Softflex 0470 is suitable for overmolding ABS, PC, ABS/PC and PPO.
| Original Document | Technical Datasheet-ASTM(English) | |||
| Appearance | Pellets/Granules | |||
| Processing | InjectionCoating | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
235°C/1.0 kg | *** g/10 min | ASTM D1238 | |
Mold Shrinkage | |||
Flow | ***~*** % | ASTM D955 | 3.18 mm |
Across Flow | ***~*** % | ASTM D955 | 3.18 mm |
Abrasion resistance | *** mg/1000cy | ASTM D 3389 | Taber Abrasion Resistance (1000 Cycles, 1000 g, H-22 Wheel) |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D 412 | |
at 50% strain | *** Mpa | ASTM D 412 | |
at 100% strain | *** Mpa | ASTM D 412 | |
at 300% strain | *** Mpa | ASTM D 412 | |
Tensile Elongation | |||
Break | *** % | ASTM D 412 | |
Flexural Modulus | *** Mpa | ASTM D790 | |
Tear Strength | *** kN/m | ASTM D 624 | |
Compression Set | *** % | ASTM D 395 | 23°C |
Tensile Set | *** % | ASTM D 412 | 100% Strain |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Falling Dart Impact | *** J | ASTM D 5420 | Gardner Impact (-30°C) |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | ***~*** A | ASTM D 2240 | |
Shore A hardness | ***~*** A | ASTM D 2240 | 10 sec |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
