Moplen Coat EP/60 BIANCO is a UV and thermal stabilized polypropylene copolymer, designed for extrusion. It is developed for continuous service at high temperature (to be designed case by case, but typically in the -20°C/+120°C temperature range for on-shore projects and up to +145°C for off-shore projects).
This product offers good resistance to impact, indentation, environmental stress cracking, chemicals, fungi and bacteria, as well as good stiffness and low water absorption.
This grade is available in white, in pellet form.
| Original Document | Technical Datasheet-ISO(English) | |||
| Features | Good StiffnessGood Impact ResistanceHeat StabilizedGood Heat AgingAntimicrobialFungus ResistantUV StabiltiyESCRChemical ResistanceCopolymer | |||
| Additive | UV-StabilizerHeat Stabilizer | |||
| Appearance | Pellets/GranulesWhite | |||
| Processing | ExtrusionExtrusion Coating | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Melt Mass Flow Rate(MFR) | |||
230°C/2.16 kg | *** g/10min | ISO 1133 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ISO 527-1/-2 | |
Tensile Elongation | |||
Break | *** % | ISO 527-1/-2 | |
Flexural Modulus | *** Mpa | ISO 178 | |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Charpy Notched Impact Strengh | |||
-20℃ (-4℉) | *** kJ/m² | ISO 179-1/1eA | Type 1, Edgewise, Notch A |
23℃ (73℉) | *** kJ/m² | ISO 179-1/1eA | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ISO 306/A50 | |
Melt Temperature(Tm) | *** °C | ISO 11357-3 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
