Lupolen 5461 B Q 471 is a high density polyethylene (HDPE) powder with high melt viscosity for extrusion of peroxide crosslinked pipes (PE-Xa). Typical application: Crosslinked pipes, PE-Xa (peroxide).
This grade is not intended for medical and pharmaceutical applications.
This grade is supported for use in drinking water applications.
| Original Document | Technical Datasheet(English) | |||
| Features | Drinking Water ContactHigh Viscosity | |||
| Processing | ExtrusionSheet ExtrusionTube Extrusion | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Melt Mass Flow Rate(MFR) | |||
190℃/5 kg | *** g/10 min | ISO 1133 | MFR measured on powder |
190℃/21.6 kg | *** g/10 min | ISO 1133 | MFR measured on powder |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ISO 527-1/-2 | 23 °C |
Tensile Strength | |||
Yield | *** Mpa | ISO 527-1/-2 | 23 °C, 50 mm/min |
Tensile Elongation | |||
Yield | *** % | ISO 527-1/-2 | 23 °C, 50 mm/min |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore D hardness | *** D | ISO 868 | 3 sec |
Ball Indentation Hardness | *** Mpa | ISO 2039-1 | H 132/30 |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ISO 306/B50 | |
Vicat Softening Temperature(VST) | *** °C | ISO 306/A50 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
