ICORENE® 3940 is a linear medium density polyethylene developed for rotational molding applications.
The resin is fully UV stabilized and suitable for general purpose applications. It has a good balance of properties such as toughness and stiffness.
| Original Document | Technical Datasheet-ASTM(English) | |||
| Features | Good StiffnessGood ToughnessAblation ResistantEasy processingUV Stabiltiy | |||
| Additive | UV-Stabilizer | |||
| Appearance | Pellets/GranulesPowderColors AvailableNatural ColorBlack | |||
| Processing | Rotational Molding | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | ***~*** g/cm³ | ASTM D 1505 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | ***~*** g/10min | ASTM D1238 | |
Environmental Stress Cracking Resistance | *** Hours | ASTM D 1693 | 10% Igepal |
Environmental Stress Cracking Resistance | *** Hours | ASTM D 1693 | 100% Igepal |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Yield | *** Mpa | ASTM D638 | 50 mm/min |
Flexural Modulus | *** Mpa | ASTM D790 | 1.3 mm/min |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Falling Dart Impact | *** J | Internal | -40°C, 3.18 mm, Rotational Molded |
Falling Dart Impact | *** J | Internal | -40°C, 6.35 mm, Rotational Molded |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
0.45 Mpa (66 psi)（4.6kg/cm²） | *** °C | ASTM D648 | Unannealed |
1.8 Mpa (264 psi)（18.6kg/cm²） | *** °C | ASTM D648 | Unannealed, 0.125 mm, Rotational Molded |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
