| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Density/Specific Gravity |
*** g/cm³
| ISO 1183 | |
Melt Volume Flow Rate(MVR) | | | |
300°C/1.2 kg |
*** cm³/10 min | ISO 1133 | |
Molding Shrinkage | | | |
Flow |
***~*** % | Internal | 2mm |
Across Flow |
***~*** % | Internal | 2mm |
Water Absorption |
*** %
| ISO 62 | 24h 50%RH |
Spiral Flow |
*** mm
| - | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | | | |
Yield |
*** Mpa | ISO 527-1/-2 | |
Tensile Elongation | | | |
Nominal Tensile Strain at Break |
*** % | ISO 527-1/-2 | |
Flexural Modulus |
*** Mpa
| ISO 178 | |
Flexural Strength | | | |
- |
*** Mpa | ISO 178 | |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Charpy Notched Impact Strengh | | | |
23℃ (73℉) |
*** kJ/m² | ISO 179-1 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Rockwell M |
*** M
| ISO 2039-2 | |
Rockwell R |
*** R
| ISO 2039-2 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | | | |
1.8 Mpa (264 psi)（18.6kg/cm²） |
*** °C | ISO 75-1/-2 | |
Relative Temperature Index(RTI), Imp | | | |
0.36/0.4mm |
*** °C | UL 746B | |
Relative Temperature Index(RTI), Elec | | | |
0.36/0.4mm |
*** °C | UL 746B | |
Relative Temperature Index(RTI), Str | | | |
0.36/0.4mm |
*** °C | UL 746B | |
Coefficient of Linear Thermal Expansion | | | |
- |
*** E-6/°C | ISO 11359-2 | |
| Flammability | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Flame Rating | | | |
V-2 |
***~*** mm | UL94 | |
| Electrical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Volume Resistivity |
*** Ohm-cm
| ASTM D257 | |
Dielectric Constant(Permittivity) | | | |
1MHz |
*** - | IEC 60250 | |
Dissipation Factor | | | |
1MHz |
*** E-4 | IEC 60250 | |
Comparative Tracking Index (CTI) | | | |
- |
*** PLC | UL 746A | |
Dielectric Strength |
*** kV/mm
| IEC 60243-1 | |
Arc Resistance |
*** PLC
| ASTM D495 | |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
