Alathon H4262 is a high-flow resin that exhibits very good cold temperature impact performance, optimum processing and thermal stability, with good color and organoleptic properties. Typical customer applications include rigid food packaging such as four, five and six-quart ice cream containers produced at high speeds in fast-cycling, multi-cavity stack molds.
H4262 meets the requirements of the Food and Drug Administration regulation 21 CFR 177.1520.
This regulation allows the use of this olefin polymer in"...articles or components of articles
intended for use in contact with food. "Specific limitations or conditions of use may apply. Contact your Equistar sales representative for more information.
| Original Document | Technical Datasheet-ASTM(English) | |||
| Features | High Impact at Low TemperaturHeat StabilizedGood ColoringFood ContactHigh Flow | |||
| Processing | InjectionBlow Molding | |||
| Compliance | FDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D 1505 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
Spiral Flow | *** mm | - | |
Bulk(Apparent ) Density | ***~*** g/cm³ | ASTM D 1895 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ASTM D638 | |
Tensile Modulus | *** Mpa | ASTM D638 | 1% Secant |
Tensile Strength | |||
Break | *** Mpa | ASTM D638 | |
Tensile Elongation | |||
Break | *** % | ASTM D638 | |
Flexural Modulus | *** Mpa | ASTM D790 | |
Flexural Modulus | *** Mpa | ASTM D790 | 1% Secant |
Flexural Modulus | *** Mpa | ASTM D790 | 2% Secant |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Izod Notched Impact Strengh | |||
23℃ (73℉) | *** J/m | ASTM D256 | |
Izod Unnotched Impact Strengh | |||
-18℃ (0℉) | *** J/m | ASTM D4812 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore D hardness | *** D | ASTM D 2240 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
0.45 Mpa (66 psi)（4.6kg/cm²） | *** °C | ASTM D648 | |
Vicat Softening Temperature(VST) | *** °C | ASTM D1525 | |
Melt Temperature(Tm) | *** °C | ASTM D3418 | |
Freezing temperature | *** °C | ASTM D 3418 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
