Versaflex OM 9140 Translucent is designed for overmolding onto a wide variety of substrates including PC, ABS, M-ABS, SAN, M-MBS, ASA, COPE, HIPS and PPE/PS blends and may be appropriate where FDA compliance is required.
New Product. Commercial specifications have not been established.
Bonds to a Variety Of Substrates
Rubbery Feel
Good surface Aesthetics
Soft Touch
Short cycle time
Good UV resistance
| Original Document | Technical Datasheet(English) | |||
| Features | Good SurfaceEasy processingFast Cycle TimeGood AdhesionMold ReleaseUV StabiltiySoft | |||
| Appearance | Pellets/GranulesTranslucent | |||
| Processing | Injection | |||
| Compliance | FDARoHS | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Viscosity | *** Pa-s | Internal | Apparent Viscosity (200°C, 11200 sec^-1) |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Break | *** Mpa | ISO 37 | 2.00 mm |
at 100% strain | *** Mpa | ISO 37 | 2.00 mm |
at 300% strain | *** Mpa | ISO 37 | 2.00 mm |
Tensile Elongation | |||
Break | *** % | ISO 37 | 2.00 mm |
Compression Set | *** % | ISO 815 | 23°C, 72 hr |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ISO 868 | 3 sec |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
