Versaflex™ GP 2810-50N is an easy processing, general purpose TPE designed for a wide variety of applications, and may be appropriate where FDA and EU 10/2011 compliances are required.
Non-Slip Grip
Overmold Adhesion to Polypropylene
Soft Touch, Rubbery Feel
| Original Document | Technical Datasheet(English) | |||
| Features | Good ColoringEasy processingGood AdhesionHigh FlowSoft | |||
| Appearance | Pellets/GranulesTranslucent | |||
| Processing | Injection | |||
| Compliance | EU 2011/10/ECFDARoHS | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ISO 1133 | |
190℃/5 kg | *** g/10 min | ISO 1133 | |
Viscosity | *** Pa-s | ISO 11443 | Apparent Viscosity (200°C, 11200 sec^-1) |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Break | *** Mpa | DIN 53504 | 2.00 mm |
at 100% strain | *** Mpa | DIN 53504 | 2.00 mm |
at 300% strain | *** Mpa | DIN 53504 | 2.00 mm |
Tensile Elongation | |||
Break | *** % | DIN 53504 | 2.00 mm |
Tear Strength | *** kN/m | ISO 34 | 2.00 mm |
Compression Set | *** % | ISO 815 | 100°C, 22 hr |
Compression Set | *** % | ISO 815 | 23°C, 72 hr |
Compression Set | *** % | ISO 815 | 70°C, 22 hr |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | DIN 53505 | 3 sec |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
