Versaflex™ CL2250 is an easy processing compound designed for use in injection molding applications where FDA compliance, clarity and enhanced heat resistance are required.
Excellent Clarity
Overmold Adhesion to Polypropylene
Superior Colorability
Very Good Heat and Boil Resistance
| Original Document | Technical Datasheet(English) | |||
| Features | Heat ResistanceGood ColoringEasy processingGood AdhesionMold ReleaseFood ContactMedical Application/Health Care | |||
| Appearance | Pellets/GranulesClear/Transparent | |||
| Processing | Injection | |||
| Compliance | FDAISO10993RoHS | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
190℃/2.16 kg | *** g/10min | ASTM D1238 | |
Mold Shrinkage | |||
Flow | ***~*** % | ASTM D955 | |
Viscosity | *** Pa-s | ASTM D 3835 | Apparent Viscosity (200°C, 11200 sec^-1) |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Break | *** Mpa | ASTM D 412 | 23°C, Die C, 2 hr |
at 100% strain | *** Mpa | ASTM D 412 | 23°C, Die C, 2 hr |
at 300% strain | *** Mpa | ASTM D 412 | 23°C, Die C, 2 hr |
Tensile Elongation | |||
Break | *** % | ASTM D 412 | 23°C, Die C, 2 hr |
Flexural Modulus | *** Mpa | ASTM D790 | |
Tear Strength | *** kN/m | ASTM D 624 | |
Compression Set | *** % | ASTM D 395 | 23°C, 22 hr |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | 10 sec |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
