OnFlex™-S KG thermoplastic elastomer compounds are based on hydrogenated styrenic block copolymers. This range of compounds are specially compatabilized to provide excellent adhesion to polyamide polymers including PA6, PA6.6, PA11 and PA12. OnFlex™-S KG can be processed by 2K molding or overmolding, insert molding or co-extrusion. In addition to this, OnFlex™-S KG compounds are formulated to provide good processability and a good cost/performance ratio, a wide hardness range, good colourability and good mechanical properties.
| Original Document | Technical Datasheet(English) | |||
| Features | Good Adhesion | |||
| Appearance | Pellets/Granules | |||
| Processing | InjectionCo-extrusion | |||
| Compliance | RoHS | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Break | *** Mpa | ISO 37 | |
at 100% strain | *** Mpa | ISO 37 | |
Tensile Elongation | |||
Break | *** % | ISO 37 | |
Tear Strength | *** kN/m | ISO 34 | |
Compression Set | *** % | ISO 815 | 100°C, 22 hr |
Compression Set | *** % | ISO 815 | 23°C, 72 hr |
Compression Set | *** % | ISO 815 | 70°C, 22 hr |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ISO 868 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
