This OnFlex™-S HS thermoplastic elastomer compounds is based on hydrogenated styrenic block copolymers. This range of compounds are formulated to deliver high strength and medium-low density in addition to typical OnFlex™-S properties such as a wide hardness range, good mechanical properties, good processability, good colourability and a wide temperature operating range.
| Original Document | Technical Datasheet(English) | |||
| Features | High Strength | |||
| Appearance | Pellets/Granules | |||
| Processing | InjectionTube Extrusion | |||
| Compliance | RoHS | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Break | *** Mpa | ISO 37 | Across Flow : 2.00 mm, Injection molded |
Break | *** Mpa | ISO 37 | Flow : 2.00 mm, Extruded |
Break | *** Mpa | ISO 37 | Flow : 2.00 mm, Injection molded |
Tensile Elongation | |||
Break | *** % | ISO 37 | Across Flow : 2.00 mm, Injection molded |
Break | *** % | ISO 37 | Flow : 2.00 mm, Extruded |
Break | *** % | ISO 37 | Flow : 2.00 mm, Injection molded |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ISO 868 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
