Elastamax™ HTE Series thermoplastic elastomers (TPEs) are based upon compounded blends of PVC resins and nitrile rubber. These elastomeric materials provide outstanding resistance to hydrocarbons and oils, offer excellent weatherability, and are an economical alternative to thermoset rubber and other more costly thermoplastic elastomers.
| Original Document | Technical Datasheet(English) | |||
| Features | Weather ResistanceOil ResistantHydrocarbon Resistant | |||
| Appearance | Pellets/GranulesNatural Color | |||
| Processing | InjectionExtrusion | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
190℃/5 kg | *** g/10 min | ASTM D 1238 | Procedure A |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Break | *** Mpa | ASTM D638 | Type IV, 510 mm/min |
at 100% strain | *** Mpa | ASTM D 638 | Type IV, 510 mm/min |
at 300% strain | *** Mpa | ASTM D 638 | Type IV, 510 mm/min |
Tensile Elongation | |||
Break | *** % | ASTM D638 | Type IV, 510 mm/min |
Tear Strength | *** kN/m | ASTM D 624 | Die C, 510 mm/min |
Compression Set | *** % | ASTM D 395 | 100°C, 22 hr |
Compression Set | *** % | ASTM D 395 | 70°C, 22 hr |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Brittleness Temperature | *** °C | ASTM D 746 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | 15 sec |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
