Dynaflex™ G7630-1 (Natural) is an easy processing, general purpose TPE designed for a wide variety of applications, including those where FDA compliance is required.
Non-Slip Grip
Overmold Adhesion to Polypropylene
Soft Touch, Rubbery Feel
| Original Document | Technical Datasheet(English) | |||
| Features | Good ColoringEasy processingGood AdhesionHigh FlowSoft | |||
| Appearance | Pellets/GranulesNatural Color | |||
| Processing | InjectionExtrusion | |||
| Compliance | FDARoHS | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
200 ℃/5 Kg | *** g/10 min | ASTM D 1238 | |
Mold Shrinkage | |||
Flow | ***~*** % | ASTM D955 | |
Viscosity | *** Pa-s | ASTM D 3835 | Apparent Viscosity (200°C, 11200 sec^-1) |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Break | *** Mpa | ASTM D 412 | 23°C, Die C, 2 hr |
at 100% strain | *** Mpa | ASTM D 412 | 23°C, Die C, 2 hr |
at 300% strain | *** Mpa | ASTM D 412 | 23°C, Die C, 2 hr |
Tensile Elongation | |||
Break | *** % | ASTM D 412 | 23°C, Die C, 2 hr |
Tear Strength | *** kN/m | ASTM D 624 | |
Compression Set | *** % | ASTM D 395 | 23°C, 22 hr |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | 10 sec |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
