| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Density/Specific Gravity |
*** g/cm³
| DIN 53479 | |
K-Value |
***~*** -
| - | 96% H2SO4 |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus |
*** Mpa
| ISO 527-2/1 | 23°C, 4.00 mm |
Tensile Strength | | | |
Break |
*** Mpa | ISO 527-2/5 | 23°C, 4.00 mm, Injection Molded |
Tensile Elongation | | | |
Break |
*** % | ISO 527-2/5 | 23°C, 4.00 mm, Injection Molded |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Charpy Notched Impact Strengh | | | |
-30℃ (-22℉) |
*** kJ/m² | ISO 179 | |
23℃ (73℉) |
*** kJ/m² | ISO 179 | |
Charpy Unnotched Impact Strengh | | | |
-30℃ (-22℉) |
*** kJ/m² | ISO 179 | |
23℃ (73℉) |
*** kJ/m² | ISO 179 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | | | |
0.45 Mpa (66 psi)（4.6kg/cm²） |
*** °C | ISO 75-2/B | Unannealed |
1.8 Mpa (264 psi)（18.6kg/cm²） |
*** °C | ISO 75-2/A | Unannealed |
Melt Temperature(Tm) |
*** °C
| ISO 3146 | DSC |
Continuous Use Temperature | | | |
Long term |
*** °C | IEC 60216 | Continuous (GTP 50% Tensile) |
Temperature at Short Circle Operation |
*** °C
| IEC 60216 | |
| Flammability | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Flame Rating | | | |
HB |
***~*** mm | Internal | ALL |
Glow Wire Flammability Index(GWFI) | | | |
0.4mm |
*** °C | IEC 60695-2-12 | |
3mm |
*** °C | IEC 60695-2-12 | |
Glow Wire Ignition Test(GWIT) | | | |
0.4mm |
*** °C | IEC 60695-2-13 | |
3.0mm |
*** °C | IEC 60695-2-13 | |
| Electrical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Volume Resistivity |
*** Ohm-cm
| IEC 60093 | |
Surface Resistivity |
*** Ohm
| IEC 60093 | |
Dielectric Constant(Permittivity) | | | |
1MHz |
*** - | IEC 60250 | |
Comparative Tracking Index (CTI) | | | |
Solution A |
*** V | IEC 60112 | |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
