Low entanglement, low bulk density UHMW-PE powder grade
| Original Document | Technical Datasheet(English) | |||
| Appearance | Powder | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Melt Mass Flow Rate(MFR) | |||
190℃/21.6 kg | *** g/10 min | ISO 1133 | |
Viscosity | *** cm³/g | ISO 1628 | Intrinsic viscosity |
Viscosity | *** cm³/g | ISO 1628 | Viscosity number (PE and PP) |
Abrasion resistance | *** - | Internal | by sandslurry method (based on GUR 4120=100) |
Particle Size | *** micrometer | Internal | d50, Laser scattering |
Bulk(Apparent ) Density | *** g/cm³ | ISO 60 | |
Average Molecular Weight | *** g/mol | Internal | Margolies' Equation |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ISO 527-2/1B | |
Tensile Strength | |||
Yield | *** Mpa | ISO 527-2/1B | |
Break | *** Mpa | ISO 527-2/1B | |
at 50% strain | *** Mpa | ISO 527-2/1B | |
Tensile Elongation | |||
Yield | *** % | ISO 527-2/1B | |
Nominal Tensile Strain at Break | *** % | ISO 527-2/1B | |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Charpy Notched Impact Strengh | |||
23℃ (73℉) | *** kJ/m² | ISO 11542-2 | Charpy double 14°v-notch |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore D hardness | *** D | ISO 868 | 15s |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Vicat Softening Temperature(VST) | *** °C | ISO 306 | 50°C/h 50N |
| Electrical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Volume Resistivity | *** Ohm-m | IEC 60093 | |
Surface Resistivity | *** Ohm | IEC 60093 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
