Internally and externally lubricated Polyamide 6,6, standard viscosity
Base polymer for fast cycle injection moulding, Cable ties
| Original Document | Technical Datasheet(English) | |||
| Features | Fast Cycle TimeDrinking Water Contact | |||
| Additive | Lubricant | |||
| Appearance | Pellets/GranulesNatural Color | |||
| Processing | Injection | |||
| Compliance | Ministerial DecreeRoHS | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
Viscosity | *** - | Internal | Solvent: sulphuric acid 95.7% |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ISO 527-2/1A | Dry, 1mm/min |
Tensile Strength | |||
Yield | *** Mpa | ISO 527-2/1A | Dry, 5mm/min |
Tensile Elongation | |||
Yield | *** % | ISO 527-2/1A | Dry, 5mm/min |
Nominal Tensile Strain at Break | *** % | ISO 527-2/1A | Dry, 50mm/min |
Flexural Modulus | *** Mpa | ISO 178 | Dry, 2mm/min |
Flexural Strength | |||
- | *** Mpa | ISO 178 | Dry, 2mm/min |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Charpy Notched Impact Strengh | |||
23℃ (73℉) | *** kJ/m² | ISO 179/1eA | Dry |
Charpy Unnotched Impact Strengh | |||
-30℃ (-22℉) | *** kJ/m² | ISO 179/1eU | Dry |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
1.8 Mpa (264 psi)（18.6kg/cm²） | *** °C | ISO 75-2/Af | |
Vicat Softening Temperature(VST) | *** °C | ISO 306/B50 | 50N, 50°C/h |
Melt Temperature(Tm) | *** °C | ISO 11357-1/-3 | Scanning rate 10°C/min |
| Flammability | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Flame Rating | |||
V-2 | *** mm | IEC 60695-11-10 | |
| Additional Information | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Yellowness Index | *** - | Internal |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
