Rilsamid® AESN BLACK P302 TL resin is a black colored polyamide 12. This grade is plasticized and designed for tube extrusion.
Rilsamid® AESN BLACK P302 TL resin falls into the PA12-HIPHL category according to DIN 73378.
| Original Document | Technical Datasheet-ISO(English) | |||
| Features | Heat StabilizedUV Stabiltiy | |||
| Additive | Light StabilizerUV-StabilizerHeat StabilizerLubricantPlasticizer | |||
| Appearance | Pellets/GranulesBlack | |||
| Processing | ExtrusionProfile ExtrusionTube Extrusion | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | Cond. |
Density/Specific Gravity | *** g/cm³ | ISO 1183 | Dry |
Melt Volume Flow Rate(MVR) | |||
235°C/5.0 kg | *** cm³/10 min | ISO 1133 | Dry |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ISO 527-1/-2 | Cond. |
Tensile Strength | |||
Yield | *** Mpa | ISO 527-1/-2 | Cond. |
Tensile Elongation | |||
Yield | *** % | ISO 527-1/-2 | Cond. |
Nominal Tensile Strain at Break | *** % | ISO 527-1/-2 | Cond. |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Charpy Notched Impact Strengh | |||
-30℃ (-22℉) | *** kJ/m² | ISO 179/1eA | Cond. |
23℃ (73℉) | *** kJ/m² | ISO 179/1eA | Cond. |
Charpy Unnotched Impact Strengh | |||
-30℃ (-22℉) | *** kJ/m² | ISO 179/1eU | Cond. |
23℃ (73℉) | *** kJ/m² | ISO 179/1eU | Cond. |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Melt Temperature(Tm) | *** °C | ISO 11357-1/-3 | Dry, 10°C/min |
Processing Temperature | *** °C | - | Injection Molding |
Mould temperature | *** °C | - | Injection Molding |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
