The FC/CS Series is your material solution for applications with food contact providing an excellent compression set. The series is available in translucent colors.
Typical applications
Closures
Flexible Connections
Household articles
Membranes
Packaging (for food and careproducts)
Seals
Valves
Material advantages
Adhesion to PP
Applications with food contact
Easy coloring (compounds in natural colors)
EN71/3
Excellent mechanical properties
FDA - Code of Federal Regulations (CFR), Title 21
For injection molding and extrusion
High elasticity
Perfect surface finish
Recyclable
Regulation (EU) No 10/2011
Service temperature: -40 °C to+120 °C (dynamic stress: up to 100 °C)
| Original Document | Technical Datasheet(English) Technical Datasheet(Chinese) | |||
| Features | Good SurfaceGood ColoringGood AdhesionFood ContactThermoplastic Elastomer | |||
| Appearance | Translucent | |||
| Processing | InjectionExtrusion | |||
| Compliance | EN71EU 2011/10/ECFDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ISO 1183 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ISO 37 | Type S2, 200 mm/min |
Tensile Elongation | |||
Break | *** % | ISO 37 | Type S2, 200 mm/min |
Tear Strength | *** N/mm | ISO 34 | Methode B (b)(Graves) |
Compression Set | *** % | ISO 815 | 100°C, 24 hr |
Compression Set | *** % | ISO 815 | 23°C, 72 hr |
Compression Set | *** % | ISO 815 | 70°C, 24 hr |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ISO 7619-1 |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
