- Blend of linear SIS triblock and SI diblock copolymer.
- Contains ~42% SI diblock copolymer.
- Low styrene, very low modulus.
VECTOR 4114A and VECTOR 4114N styrenic block copolymers are blended products composed of a linear SIS triblock copolymer and an SI diblock copolymer. They are softer than VECTOR 4113A SIS/SI due to higher diblock content, making them well-suited for use in hot melt pressure sensitive adhesives, elastomer compounds and photopolymer plate applications.
- VECTOR 4114A SIS/SI is offered as a dense pellet supplied from the United States.
- VECTOR 4114N SIS/SI is offered as a porous pellet supplied from China.
| Original Document | Technical Datasheet(English) | |||
| Appearance | Pellets/Granules | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
200 ℃/5 Kg | *** g/10 min | ASTM D 1238 | |
Viscosity | *** Cps | ASTM D 2196 | Solution Viscosity, in 25 wt% Toluene (25°C) |
Bulk(Apparent ) Density | *** g/cm³ | ASTM D 1895 | |
Filled/Ash | *** % | ASTM D 5630 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
Break | *** Mpa | ISO 37 | |
at 300% strain | *** Mpa | ISO 37 | |
Tensile Elongation | |||
Break | *** % | ISO 37 | |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | 1 s |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
