ecovio® FT2341 is our new biodegradable film product based on renewable resources. It is basically a compound of our biodegradable, aliphatic-aromatic copolyester grades ecoflex® F and ecoflex® FS and a small amount of polylactic acid (PLA). ecovio® FT2341 has a biobased content of 34%. Due to its outstanding mechanical strength ecovio® FT2341 offers a great down gauging potential needed for very thin film applications like T-shirt, organic waste and fruit & vegetable bags etc. ecovio® FT2341 does not contain slip agents. ecoflex® slip masterbatches have to be used to tailor the sliding properties required for easy processing on film extrusion and film conversion equipment.
Our new ecovio® FT2341 exhibits the following key properties:
• Transparent to translucent, semi-crystalline structure with DSC melting points in the range of: 110-120°C and 140-155°C
• High melt strength: MVR (190°C/5kg): 2.5-7.5ml/10min.
• Good thermostability up to 230°C
• High mechanical strength and tear propagation resistance
• Good processability on conventional PE-LD blown film lines
• Suitable for very thin film applications
| Original Document | Technical Datasheet(English) | |||
| Features | Easy processingBio-basedDegradableFood ContactHigh melt strength | |||
| Appearance | Pellets/GranulesClear/TransparentTranslucent | |||
| Processing | ExtrusionFilm ExtrusionBlow Molding | |||
| Compliance | EU 2011/10/ECFDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | ***~*** g/cm³ | ISO 1183 | Mass Density |
Melt Volume Flow Rate(MVR) | |||
190°C/5.0 kg | ***~*** cm³/10 min | ISO 1133 | |
Bulk(Apparent ) Density | *** g/cm³ | ISO 60 | Bulk Density |
Biobased content | *** % | - | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Melt Temperature(Tm) | ***~*** °C | DSC | PLA |
Melt Temperature(Tm) | ***~*** °C | DSC | ecoflex® |
| Film | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ISO 527 | MD : 25 µm, Blown Film |
- | *** Mpa | ISO 527 | TD : 25 µm, Blown Film |
Tensile Elongation | |||
Break | *** % | ISO 527 | MD : 25 µm, Blown Film |
Break | *** % | ISO 527 | TD : 25 µm, Blown Film |
Tensile Modulus | *** Mpa | ISO 527 | MD : 25 µm, Blown Film |
Tensile Modulus | *** Mpa | ISO 527 | TD : 25 µm, Blown Film |
Elmondorf Tear | *** N | ISO 6383-2 | MD : 25 µm, Blown Film |
Elmondorf Tear | *** N | ISO 6383-2 | TD : 25 µm, Blown Film |
Dart Drop Impact | *** g | ASTM D 1709 | 25 µm, Blown Film |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
